Installing The Reservoir - Keurig K-2500 Use & Care Manual

K-2500™ BREWER

Installing the Reservoir

If you have purchased the K-2500™ Water Reservoir Kit, follow the simple instructions below to get it installed.
NOTE: Rinse the reservoir with clean water prior to use.
1
Remove
Locking
Screw
To install the Water Reservoir Kit,
first remove the locking screw.
When facing the rear of the
brewer, the screw is located on
the bottom right corner. Save the
screw and set it aside; you will
need it in Step 3.
WATER HOOKUP, CONT.
2
Insert Dock
Slide the dock into the left-hand
side of the brewer until it clicks into
place; the "click" indicates that it is
properly connected.
3
Secure Dock
Secure the dock to the brewer by
replacing the locking screw from
Step 1.
NOTE: If it is difficult to reinsert
the screw, gently nudge the
dock closer to the brewer while
tightening the screw. This should
assist the screw to catch so the
dock can be fully attached.
Please DO NOT skip this step.
Failure to secure the dock with the
screw can cause leakage issues.
4
Place Reservoir
Fill the reservoir with water up to the
MAX fill line, then place the reservoir
on the dock.
For reservoir installation video:
commercial.keurig.com/training.
8