Water Hookup; Plumbing Instructions - Keurig K-2500 Use & Care Manual

K-2500™ BREWER
If you have purchased the K-2500
Reservoir Kit, skip to "Installing the Reservoir"
on page 8.

Plumbing Instructions

CAUTION: This brewer is designed to handle local water pressures from 40 psig
up to 125 psig. Consult a licensed plumber for water pressures in your area. Use
plumbing fittings and tubing specified to withstand 125 psig.
WARNING: Keurig® requires the use of an external water filter such as the
Omnipure KQ8A Water Filter, available from Keurig®. Failure to use a filter
invalidates the brewer warranty.
NOTE: The equipment shall be installed with adequate backflow protection
to comply with applicable federal, state, and local codes.
1. Remove all pieces of packing tape from the brewer and drip tray.
Remove the clear plastic film from the touch screen.
NOTE: An external filter (KQ8A, #5572) can be mounted on the rear surface
of the brewer using the mounting screws provided.
2. Attach a threaded straight adapter to both the IN and OUT ports on
the Omnipure KQ8A Water Filter and tighten using an 11/16" (18 mm)
wrench. Make sure the connections are secure, but do not overtighten.
3. Attach the filter mounting bracket to the Omnipure KQ8A Water Filter
using the four screws provided.
NOTE: The top of the Omnipure KQ8A Water Filter has two ports labeled
IN port and OUT port. Make sure these ports are aligned with the filter
mounting bracket.

WATER HOOKUP

4. Loosen the two mounting screws located on the upper rear of the
Water
™ brewer and hang the filter kit assembly. Tighten the screws, being
careful not to overtighten.
NOTE: The filter kit assembly comes with ¼" FPT ports for both inlet and outlet,
and the plumbed water inlet to the brewer is ¾" female garden hose thread
(Invensys solenoid valve). ¼" OD LLDPE (Linear Low Density Polyethylene)
tubing is recommended (NSF® compliant) between the filter kit assembly and
the brewer. NSF® compliant fittings such as High Density Polypropylene type
are recommended.
Shut-off Valve
LLDPE Tubing
Continued
Screws (4x)
Filter Mounting
Bracket
IN Port
OUT Port
Stem
Elbow
Fitting
(3x)
Threaded
Straight
Adapter (2x)
3/4" Female Garden
Hose Connector
6