2.1.1 Removal, Maintenance and Installation
1)Remove the bolt of oil passage and kick the starter rod to run the engine.
Check to see if oil flows from the view-hole. Clean the oil passage/line, if
necessary.
(NOTE: Bolt specification: M6×12
2)Unscrew the fixing bolt of valve cover and remove the valve cover.
(NOTE: Bolt specification: M6×12
CHAPTER 2 ENGINE
2.1 CYLINDER HEAD
Tightening torque of bolt 8~12N·m)
Tightening torque of bolt 8~12N·m)
3)Adjust the valve gap.
4)Unscrew and remove the fixing bolt M8 of cylinder head.
(Tightening torque30~40N.m)
2-
1