Lifan LF200-10P Manual page 32

15）Remove the mainshaft comp. and countershaft comp., then check them for
proper match gap. Replace the mainshaft comp. and countershaft comp. if the
gap is too large.
16）Check the gears of mainshaft comp. and countershaft comp. for wear.
Replace them if necessary (it needs to replace the gear if defects such as pits,
teeth crack appear).
17） Remove the washer of starting mid-gears. Check it for wear and replace it if
the worn part is out of the limit.
18）Remove the starting mid-gears on the counter shaft. Check it for wear.
Replace it if it is out of the limit.
Limit value of inner bore: Φ 20.1mm
2-24
Service limit: 0.8mm