Usel" Is Indicated On The Lcd Display And The Scales Switch Off; Err" Is Indicated On The Lcd Display; Err2" Is Indicated On The Lcd Display; Maintenance / Cleaning - Silvercrest SPWD 180 F1 Operating And Safety Instructions Manual

SilverCrest SPWD 180 F1
9.3. "USEL" is indicated on the LCD display and the scales switch
off.

An error has occurred and the diagnostic scales cannot perform the measurement. In this
case, step off the tread (5) of the diagnostic scales and start the measurement again.

9.4. "Err" is indicated on the LCD display.


Your weight exceeds the maximum load capacity of 180kg / 396lb / 28st. You should step
off the tread (5) of the diagnostic scales immediately to avoid damaging the scales.

9.5. "Err2" is indicated on the LCD display.


An incorrect measurement has occurred. In this case, step off the tread (5) of the diagnostic
scales and start the measurement again. Make sure that you are standing on both electrodes
(6).

10. Maintenance / cleaning

It is necessary to service the diagnostic scales if they have been damaged in any way, for example,
if the housing is damaged, if liquid or objects have penetrated the diagnostic scales or if they have
been exposed to rain or moisture. Servicing is also required if the device is not working properly or
has been dropped. If smoke is produced, or there are any unusual sounds or smells, remove the
battery immediately from the diagnostic scales. In such cases, the diagnostic scales should not be
used until they have been inspected by authorised service personnel. Only have qualified personnel
carry out the servicing on the device. Never open the housing of the diagnostic scales. Only use a
clean, dry cloth for cleaning and never use any corrosive liquids.
28 - English