Emerson SolaHD STC-HSP Series Manual
Emerson SolaHD STC-HSP Series Manual

Emerson SolaHD STC-HSP Series Manual

Surge protective devices

Advertisement

Quick Links

Surge Protective Devices
STC-HSP Series

Advertisement

Table of Contents
loading

Summary of Contents for Emerson SolaHD STC-HSP Series

  • Page 1 Surge Protective Devices STC-HSP Series...
  • Page 2: Safety Information

    Safety Information Important Information Read these instructions carefully and look at the equipment to become familiar with the device before trying to install, operate, service or maintain it. The following special messages may appear throughout this bulletin or on the equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a procedure.
  • Page 3 STCHSP121BT1RU Introduction The STCHSP121BT1RU is an advanced 3-stage hybrid, solid state power line protective device. Features such as noise filtering, common mode and normal mode suppression, nanosecond reaction time, power line tracking, and compression screw terminations, make this device an excellent choice in commercial and industrial applications.
  • Page 4: Installation

    STCHSP121BT1RU Installation 1. Turn off all power supplying this equipment before working on or inside equipment. 2. Mount the STCHSP121BT1RU in a UL-approved housing. Keep all leads as short as possible. 3. Position unit within the equipment cabinet so that the fuse holder is accessible. 4.
  • Page 5 STCHSP121BT1RU Figure 1: STCHSP121BT1RU fuse holder location Dimensions (in. / mm.) EXPOSED TERMINAL DESIGN Holes 3/16 [4.76] DIA 1.17 [29.72] 2.95 STC-SLAC Series NEUTRAL [74.93] NEUTRAL Surge Protective Device 1.17 STC-HSP121BT1RU GROUND GROUND [29.72] LIGHT ON: NORMAL LIGHT OFF: SERVICE 4.86 [123.44] 5.25 [133.35] Page: 3...
  • Page 6: General Technical Specifications

    STCHSP121BT1RU General Technical Specifications Operating Voltage 120 VAC Clamping Voltage 200-240 VAC Operating Current 15 A Peak Surge Current 39 kA (8 x 20 µs) Operating Frequency 47-63 Hz EMI Attenuation > 40 dB (100 kHz to 100 MHz) SPD Technology Metal Oxide Varistors (MOVs) w/ L-C Filter Modes of Protection Line-to-Neutral, Line-to-Ground,...
  • Page 7: Technical Support

    STCHSP121BT1RU Technical Support Website: www.solahd.com Technical Support E-Mail: solahd.technicalservices@emerson.com Toll-Free: (800) 377-4384 USA: (847) 268-6651 Warranty Please see the “Terms & Conditions of Sale” document. While every precaution has been taken to ensure accuracy and completeness in this manual, Appleton Grp LLC d/b/a Appleton Group assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions.
  • Page 8 The Emerson logo is a trademark and service mark of Emerson Electric Co. Appleton Grp LLC d/b/a Appleton Group. SolaHD is a registered trademark of Appleton Grp LLC. All other marks are the property of their respective owners. © 2020 Emerson Electric Co. All rights reserved. United States...

This manual is also suitable for:

Solahd stchsp121bt1ruSolahd hsp121bt1ruSolahd stc-slac series

Table of Contents