Electromagnetic Compatibility (Emc) To En60601-1:2007 - Micro Direct MicroLoop Operating Manual

During database upload, the MicroLoop may be connected to a
computer that complies with EN 60950 – 'Information technology
equipment – Safety – Part 1: General requirements'.
IMPORTANT: Only use the mains adapter supplied (PSU1013 5V
DC 2.0A). The adapter contains a transformer. Do not cut off the
adapter to replace it with another plug as this causes a hazardous
situation. Turn off the mains supply or remove the MicroLoop from
the charger once the battery display shows fully charged.
 The adapter transforms the mains voltage (100-240 Volts)
to a safe voltage (5V DC)
 Make sure the adapter does not get wet
 Do not use a damaged adapter
 Always unplug your MicroLoop before cleaning
WARNING: Do not connect devices that are not specified as part
of the system.
Note: If an MPSO (Multiple Portable Socket Outlet) is used with
the system, the maximum permitted load should not be exceeded.
Do not connect electrical equipment that has not been supplied as
part of the system.
WARNING: To avoid risk of electric shock, this equipment must
only be connected to supply mains with protective earth.
Electromagnetic Compatibility (EMC) to EN60601-
1:2007
WARNING: use of portable phones or other radio frequency (RF)
emitting equipment near the system may cause unexpected or
adverse operation.
The MicroLoop has been tested to EN60606-1-2:2007, regarding
the ability to operate in an environment containing other
electrical/electronic equipment (including other medical devices).
The purpose of this testing is to ensure that the MicroLoop is not
likely to adversely affect the normal operation of other such
equipment and that other such equipment is not likely to adversely
affect the normal operation of the MicroLoop.
27