Table of Contents
Advertisement
products are: lead-based inks; brick silica crystal,
cement and other masonry products; and arsenic and
chromium from chemically treated wood.
CAUTION: Do not connect the unit to an
electrical outlet until all instructions have been read and
understood.
Always tighten the adjustment clips before using the
machine. Keep your hands 15 cm away from the tape.
Never perform hands-free operations. Never cross your
arms in front of the tool. Think: "I can avoid accidents"
Do not operate the machine without the guards in place.
Always wear safety glasses. Turn off the machine and
wait for the tool to stop before restarting service, making
adjustments or moving your hands.
Electrical Connection
The Ribbon Saw SF.250.C MAKSIWA has a single-
phase motor with connection option 110 and 220V. To
avoid burning risks, the motor leaves the factory
connected to 220V. Check the electrical voltage of your
outlet before starting the machine. If necessary, change
the electrical connection of the motor with the help of a
specialized technician.
Make sure your power supply matches the designation
on the plate. A 10% decrease in voltage or more will
cause loss of power and overheating. All MAKSIWA
equipment is tested at the factory. If this tool does not
work, check the power supply.
Check the compatibility between your outlet and the
machine's plug. Avoid making patches and adaptations.
Familiarize yourself with the machine
Place the machine on a smooth, flat surface. Check the
figures and pay attention to the description of the parts to
familiarize yourself with its different components. The
next section will deal with the necessary adjustments for
a good functioning of the machine, and will refer to the
termination that accompanies the illustrations.
To do this, you must know these parts and you must
know where they are. The name of each component is
followed by a corresponding number in the illustration.
Specifications
Wattage
Motor Speed
Tape Speed
Tape Dimension
Max Cutting Widht
Max Cutting Height
Table Dimension
Table Tilt
Net Weight
Transport and Installation
For packaging reasons, the machine is not completely
assembled.
If you notice any damage caused by transportation while
opening the package, notify your supplier immediately.
Do not operate the machine.
Dispose the packaging in a sustainable
environmental way.The MAKSIWA Band Saw
SF.250.C is designed to operate indoors and must be
placed on a firm, stable and level surface. CAUTION: To
prevent the machine from moving and causing a lack of
precision, make sure that the base on which it is
supported is not uneven. If the machine moves on the
surface, place a support under the base until it settles
firmly on the surface.
UNPACKING AND ASSEMBLY
UNPACKING
Due to modern mass production techniques, the
SF.250.C MAKSIWA Band Saw is unlikely to be
defective or a part is missing. If you find something
wrong, do not use the tool until the parts are replaced,
or the fault is corrected.
By doing this you are avoiding serious bodily injury.
1. Remove all loose parts from the packaging.
2. Remove the packaging materials around the
6
½ HP (370 W)
1.720 RPM
780 m/min
1.750 x 6 a 13 mm
245 mm
100 mm
350 x 330 mm
0º a 45º
22,5 mm
AS
Advertisement
Table of Contents
