Table of Contents
Advertisement
Lights
None
Solid Green
Flashing Blue (slow)
Flashing Blue (fast)
Solid Blue
Flashing Red
Place your BryFi transmitter in a location where you can easily connect your source material. It is recommended that the transmitter
and speakers are within "sight" of one another.
Plug the round connector from the supplied power brick in to the power jack on the back of your BryFi transmitter.
Press the white power button. You should see a green LED illuminate.
In approximately 45 seconds you will hear a xylophone start-up sound, followed by a flashing blue LED, indicating that the system is
in hotspot mode and ready to be added to your home WiFi network.
In order for your wireless speakers to receive a signal from the wireless transmitter, they need to be synced/paired. This process only
needs to be performed once as all the components will remember each other, even after disconnecting the power.
On the transmitter: Press and hold the white Power/Sync or Sync button until the green light starts flashing rapidly.
On the first speaker: Press and hold the white Power/Sync or Standby/Sync button until the green light is solid. Note that the green
indicator light on the transmitter will also now be solid.
Repeat the steps above for the second speaker and confirm that the green indicator light next to the sync button is solid on the
transmitter and both speakers. Your wireless speakers are now ready to use!
Recommendations:
The most reliable wireless signal quality will be achieved by placing the transmitter and speakers within "sight" of one another. If you
notice interruptions in the audio signal, try moving the transmitter to another location.
Find the Section in the following pages for your device type
Section 1 – iOS devices
Section 2 – Android Devices
Section 3 – Windows PC
Section 4 – Mac computer
2
Status Lights
Status/Description
BryFi is off
BryFi is on
BryFi is in hotspot mode
BryFi is in hotspot mode and is in WiFi accessory configuration mode
BryFi is connected to local WiFi / wired network
BryFi is out of range of local network / configuration error
Connect to Power
Turn On
Sync / Pair Speakers
Connect to WiFi
Advertisement
Table of Contents
