Table of Contents
Advertisement
•
Make sure that the cutter on the trimmer guard is
intact. This cuts the trimmer line to the correct
length.
•
Soak the trimmer line in water for a couple of days
before use to increase the life length.
Saw blade and grass blade
•
Use correctly sharpened blades. An incorrectly
sharpened or damaged blade increases the risk of
injury.
•
Use correctly set blades. Correct blade set is 1 mm.
An incorrectly set blade increases the risk of injury
and damage.
•
To sharpen and set the blade correctly, refer to the
instructions that come with the blade.
Fuel Safety
WARNING:
instructions that follow before you use the
product.
•
Never start the product if you spill fuel on it. Wipe the
spillage of and allow remaining fuel to evaporate.
•
Never start the product if you spill fuel on yourself or
your clothes. Change your clothes and wash any
part of your body that has come in contact with fuel.
Use soap and water.
•
Never start the product if the product is leaking fuel.
Check regularly for leaks from the fuel cap and fuel
lines.
•
Always put the product on a flat surface and make
sure the cutting attachment cannot come in contact
with any object while you add fuel.
•
Take care when handling fuel. Bear in mind the risk
off fire, explosion and inhaling fumes.
•
Observe caution when handling fuel and make sure
there is adequate ventilation. Fuel and fuel fumes
are highly inflammable and can cause serious injury
when inhaled or allowed to come in contact with the
skin.
•
Mix and pour fuel outdoors, where there are no
sparks or flames.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
WARNING:
cable from the spark plug before you
assemble the product.
1643 - 001 - 07.04.2021
Read the warning
Assembly
Before you assemble the
Remove the spark plug
•
Do not smoke or place hot objects near fuel.
•
Always stop the engine and let it cool off for a few
minutes before you refuel.
•
Open the fuel cap slowly so that any excess
pressure is released gently when you refuel.
•
Tighten the fuel cap carefully after you refueled.
•
Clean the area around the fuel cap. Contamination in
the tank can cause operating problems.
•
Always move the product 3m (10ft) or further from
the refuelling area and source before starting.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
•
Stop the engine, make sure that the cutting
attachment stops and let the product cool down
before you do the maintenance.
•
Disconnect the spark plug cap before you do the
maintenance.
•
The exhaust fumes from the engine contain carbon
monoxide, an odorless, poisonous and very
dangerous gas that can cause death. Do not run the
product indoors or in closed spaces.
•
The exhaust fumes from the engine are hot and can
contain sparks. Do not run the product indoors or
near flammable material.
•
Accessories and changes to the product that are not
approved by the manufacturer, can cause serious
injury or death. Do not change the product. Always
use original accessories.
•
If the maintenance is not done correctly and
regularly, there is an increased risk of injury and
damage to the product.
•
Only do the maintenance as this operator's manual
recommends. Let an approved Husqvarna service
agent do all other servicing.
•
Let an approved Husqvarna service agent do
servicing on the product regularly.
•
Replace damaged, worn or broken parts.
Read the warning
11
Advertisement
Table of Contents
