Husqvarna 524R Operator's Manual page 12

To assemble the handlebar
1. Remove the screw behind the throttle handle.
2. Move the throttle handle to the right side of the
handlebar.
3. Align the hole behind the throttle handle with the
hole in the handlebar.
4. Put the screw go through the holes. Tighten the
screw.
5. Attach the handlebar between the arrows on the
shaft. Tighten the screw.
To install the harness
1. Put on the harness and hang the product from the
suspension point.
2. Adjust the handle to put the product in a good work
position.
3. Tighten the screws fully.
12
To set the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar clockwise until the throttle handle
touches the battery.
3. Turn the handlebar around the shaft.
4. Tighten the knob.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING:
WARNING:
attachment guard that is recommended for
the cutting attachment. See
page 29 .
WARNING:
cutting attachment can result in injury or
death.
To install a blade guard, grass blade and
grass cutter
CAUTION:
guard for the blades. See
page 29 .
1. Attach the blade guard/cutting attachment guard (A)
onto the shaft and tighten with the bolt.
G
F
E
2. Install the drive disc (B) on the output shaft.
Use protective gloves.
Always use the cutting
Accessories on
An incorrectly attached
Only use the approved
Accessories on
A
D
1643 - 001 - 07.04.2021
B
C