Table of Contents
Advertisement
2. Clean the area around the fuel tank cap.
3. Remove the fuel tank cap slowly to release the
pressure.
4. Fill the fuel tank.
CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
5. Tighten the fuel tank cap carefully.
6. Clean fuel spillage on and around the product.
7. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
Product overview on page 3 .
refer to
Work position
•
Hold the product with 2 hands.
•
Hold the product on the right side of your body.
•
Keep the cutting attachment below waist level.
•
Always keep the product attached to the harness.
•
Keep body parts away from the hot surfaces.
•
Keep body parts away from the cutting attachment.
To start a cold engine
1. Set the stop switch to the start position.
2. Set the choke control (A) to the choke position.
B
3. Push the air purge bulb (B) approximately 6 times
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
16
Make sure that there is
C
A
4. Push the decompression valve (C).
Note:
The decompression valve moves to the
initial position when the product starts.
5. Hold the body of the product on the ground with your
left hand.
CAUTION:
the product.
6. Pull the starter rope handle slowly until you feel
some resistance. When you feel resistance, pull the
starter rope handle quickly and with force.
Note:
Do not wind the starter rope around your
hand.
7. Continue to pull the starter rope handle until the
engine starts.
CAUTION:
rope to full extension and do not let go of
the starter rope handle. Release the
starter rope slowly. If you do not obey
these instructions, the engine can
become damaged.
8. Set the choke control to the operation position and
apply full throttle.
To start a warm engine
1. Set the stop switch to the start position.
Do not put your feet on
Do not pull the starter
1643 - 001 - 07.04.2021
Advertisement
Table of Contents
