Advertisement
Step 3:
a)
Take out the pre-installed Bolt (27), Spring Washer (20) and Washer (28) from the
Handlebar post (6).
b)
Insert the Swing Rod (L) (3) and Swing Rod (R) (4) into to the left and right sides of
the Handlebar Post (6) respectively. Secure using a Bolt (27), Spring Washer (20)
and Washer (28). Tighten with the supplied Spanner (114), then attach the End
Cap (31).
c)
Insert the Bolt (49) and Wave Washer (51) through the Rear Connector (8), then
rotate it counter-clockwise and secure it on the left of the Crank (72) with the
supplied Spanner (111). Then fix it clockwise with a Spring Washer (54), Nut (52) and
Spanner (113) as per the picture. Finally, attach the End Cap (55).
d)
Insert the bolt (50) Wave Washer (51) through the Rear Connector (8), then rotate
it clockwise and secure it on the right of the Crank (72) with the supplied Spanner
(111). Then fix it counter-clockwise with a Spring Washer (54), Nut (53) and Spanner
(113) as per the picture. Finally, attach the End Cap (55).
Advertisement
