Advertisement
Step 6:
1.
Secure the Middle Handlebar (7) to the Handlebar Post (6) with a Bolt (24), Spring
Washer (20) and Arc Washer (18). Tighten with the supplied Spanner (112).
2.
Remove the Bolt (16) from the rear of the Computer (103). Connect the Computer
Wire (103a) with the Trunk Wire (104), then secure the Computer (103) to the
Handlebar Post (6) with the Bolt (16).
3.
Insert the Handle Pulse Wire (108) into the hole on the back the of Computer (103).
The installation is complete.
Advertisement
