Assembly Instruction - Westfalia 816172 Instruction Manual

Tools required for Assembling

10 mm & 13 mm wrenches (included)
 Cross-head screwdrivers
Assembling
1. Before assembling, check the material for
completeness (refer to the parts list).
2. Use the cross-head screws (10), the
washers (11) and the nuts (15) to assem-
ble the crossbars (4) with the leg frames
(6) and (7). This way you assemble the
tabletop support (figure 1).
3. Place both worktops (2) and (3) with the
small bore holes facing up on a flat level
and clean surface (e.g. workbench). Use
the wood screws (16) to attach the crank
handle units (8) as pictured in figure 2, to
the worktops.
4. Fit the assembled leg frames into the
crank handle units (8). Line up the holes in
the crank handles units with the holes in
the leg frames. Insert the hex bolts (14)
and the washers (12) from outside of the
crank handle units. Attach washers (12)
and nuts (13) from the inside (figure 3).
5. Attach plastic foot caps (5) on each table
leg end of the leg frames (6) and (7). Pay
attention to attach each cap with the longest side at the outer
corner.
6. Select suitable holes on the worktops to fix the four chocks (1).
The chocks can be removed and repositioned at any time.

Assembly Instruction

8
1
2
3