Advertisement
English
MODE 1, STEAM AUTOMATIC STOP
A temperature is set at the “T stop steam xxx°C" field using the "+"
and "-" keys, with "xxx" which ranges from a minimum of 50°C and
a maximum of 85°C.
Steam dispensing is controlled by the knob (13).
In particular:
- when the knob is turned to the right, the milk is heated.
- When the knob is turned to the left, the milk is frothed.
Once the knob has been turned (13), it automatically returns to the
"O" position.
The message "T steam xxx°C"
appears on the display, indicating
the temperature read by the probe.
Note: When the set temperature is reached, steam supply stops
automatically and the display continues indicating steam value
for the next 3 seconds.
Steam supply can be interrupted at any time (even if the set
temperature was not reached), by again turning the automatic steam
knob (13) in the same direction used for activating supply.
MODE 2, STEAM MANUAL STOP
Set the temperature value on item
Steam dispensing and the choice of milk
MODE 1.
The message "T steam xxx°C"
appears on the display, indicating
the temperature read by the probe.
Note: The user controls when steam dispensing is stopped.
When the desired temperature is reached, the user will turn the
automatic steam knob (13) in the same direction used to start the
steam dispensing process.
For the next 3" after steam dispensing has stopped, the display
shows the milk temperature that has been reached.
Note: If the milk is frothed, the
xxx°C".
If the milk is warm, the
"Steam
T:
xxx°C".
Time out is set at 180" for both the programming modes.
BEVERAGE TEMPERATURE READING
The steam probe also detects the beverage temperature, but only if
it is higher than 50°C. Inset the steam nozzle (15) into the container,
making sure the tip is completely submerged in the milk. After a few
seconds the phrase "T steam: xxx°C", corresponding to the probe
reading, appears.
When the steam nozzle is removed from the milk, the phrase remains
on the display for the following 3 seconds.
To view the temperature in Fahrenheit degrees, please refer to the
"configuration menu -Measurement unit" in the technical manual.
Steam dispensing
14 January
2004
wednesday
15:15:04
T steam:
064°C
"T stop steam xxx°C" at "000" zero.
type are performed as in
14 January
2004
wednesday
15:15:04
T steam:
050°C
symbol appears beside "Steam
symbol appears beside
Frothed
m i l k
If the thermocouple is malfunctioning, the Error Log will list the ES-
053 error. The latest set temperature value is, however, saved until
thermo-couple operation is restored. The machine works as if it is
in the STOP STEAM mode. You can froth or heat milk, but during the
process, the display will show:
The temperature detected by the probe will appear again on the
display once the thermocouple functions again.
T:
The ideal setting for milk frothing is set in the factory. If additional
adjustments must be made, turn the flow adjustment valve (A)
underneath the panel control of the machine:
-
counterclockwise: more air > more frothy milk
-
clockwise: less air > less frothy milk
Note: even slight turns of the valve (A) can make a great
difference in how the milk is frothed.
13
Hot milk
14 January
2004
wednesday
15:15:04
T steam:
- - - °C
English
A
Advertisement
