Display Time - Belkin OmniView MATRIX F1D208-OSD User Manual

F1D208-OSD_EU_man.qxd 4/20/00
SCAN TIME:
Amount of time the OmniView
one port before switching to the next port when in
Scan Mode

DISPLAY TIME:

Amount of time the OSD Menu or Port Name remains
displayed on-screen after making a port selection
NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are set on the MASTER unit only,
and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all the active BANKS (if there are slave units present) and then
puts the unit in AutoScan mode. If the unit is a single MASTER unit, pressing the button immediately invokes
AutoScan mode. This is evident by a long BEEP, followed by two short beeps.
You can delete all the OSD names stored in memory, and change them back to the factory default ("Channel 1,"
"Channel 2,") etc. names by pressing [scroll lock] [scroll lock] [DELETE]. You must wait 30 seconds for the memory to
be reinitialized.
4:37 PM Page 14
Usage
(continued)
SCAN TIME:
MATRIX stays on
™
7sec
DISPLAY TIME:
7sec
[ ]: SELECT
(INS):
(Enter): COMPLETE
(Esc):
Erasing all the OSD names stored in memory.
14
15sec 30sec 60sec
15sec 30sec 60sec
RENAME
Exit