Installation - Bowers & Wilkins CDA-16 Manual

1. CDA-16 Carton Contents
1 x Power cable
2 x Rack-mount ears
4 x Rack-mount ears screws
4 x Feet
4 x Feet screws
8 x 5.08mm Pitch 4-way Phoenix Combicon style

2. Installation

2.1 Rack mounting
CDA-16 is intended to be installed in a standard 19-
inch equipment rack. It is supplied with rack mount
ears, but not rack mount bolts and nuts. Ensure
that, once mounted in the rack, the amplifier is well
ventilated and that the ventilation apertures are not
obstructed. If the system is taken out of use for a
long period, disconnect the amplifier from the mains
power supply.
The CDA-16 is supplied with two rack mounting ears
for installation in standard equipment racks. Attach
the brackets by inserting machine screws through
each bracket into the threaded holes in the side of
the amplifier, see Diagram 2.
To prevent damage, maintain adequate
ventilation space to the sides of the
amplifier. CDA-16 can be stacked vertically
but be sure not to place the amplifier next to other
components, or against the side of a cabinet. Doing
so will block ventilation openings.
2.2 Foot mounting
CDA-16 can also be table mounted and is supplied
with feet and feet screws, see Diagram 3.
Ensure that, once positioned, the amplifier is well
ventilated and that the ventilation apertures are not
obstructed. If the system is taken out of use for a
long period, disconnect the amplifier from the mains
power supply.
To prevent damage, maintain adequate
ventilation space to the sides of the
amplifier. CDA-16 can be stacked vertically
but be sure not to place the amplifier next to other
components, or against the side of a cabinet. Doing
so will block ventilation openings.
1 x
1 x
Diagram 1
Contents
warm air
Diagram 2
Rack mounting
Diagram 3
Foot mounting
2 x
4 x 4 x
4 x
8 x
cool air
3