Function
Cellular USB
(two UARTs)
GNSS VCC supply
GNSS USB
NEO GNSS Timepulse
Cellular / GNSS I2C
Table 2: EVK-R4 LED descriptions
1.5 Connectors
Function
9 - 18 V Power Input
SIM card holder
Cellular USB
(main UART)
Cellular RS232
(main UART)
Cellular antenna
GNSS antenna
(for SARA-R422M8S)
Cellular native USB
Cellular USB
(two UARTs)
DIL B2B headers
GNSS antenna
(for NEO-M8N)
GNSS USB
GNSS backup battery Backup battery socket for the GNSS module (under GNSS adapter board)
Cellular headset
GND
Table 3: EVK-R4 connector descriptions
⚠
Caution! In the unlikely event of a failure in the internal protection circuitry, there is a risk of
explosion when charging a fully or partially discharged battery. Replace the battery when it no
longer has a sufficient charge for unit operation. Control the battery before use if the device has
not been used for an extended period.
⚠
Caution! Risk of explosion if the battery is replaced with an incorrect type. Dispose of used
batteries according to the instructions!
UBX-16029216 - R07
C1-Public
Description
USB cable plugged in the Cellular USB connector (J201) on the
ADP-R4, for access to the two UART interfaces of SARA-R422M8S
NEO-M8N GNSS module supply is turned ON
USB cable plugged into the GNSS USB connector for NEO-M8N
NEO-M8N GNSS TimePulse output
Cellular / GNSS module communication over the DDC (I
Description
Connector for the AC / DC power adapter of the EVK
AC: 100-240 V, 0.8 A, 50-60 Hz / DC: +12 V, 2.5 A
SIM card holder
Mini USB connector for the cellular module main UART interface converted
as a USB interface
DB9 connector for the cellular module main UART interface converted as an
RS232 interface
SMA connector for the cellular module antenna (ANT, Tx/Rx)
SMA connector for the GNSS antenna to be connected to the GNSS RF
input of the SARA-R422M8S module (ANT_GNSS)
Mini USB connector for the cellular module native USB interface
Mini USB connector for the two UART interfaces of the SARA-R422M8S
module converted as a USB interface
Dual-in-line board-to-board connectors for cellular module interfaces
SMA connector for the GNSS antenna to be connected to the GNSS RF
input of the NEO-M8N GNSS module (RF_IN)
Mini USB connector for the GNSS module USB interface
Audio headset jack connector for the cellular module audio interface
Ground terminals for the probe reference
2
C) interface
IEC 60417-5172
Class II equipment
Starting up
EVK-R4 - User guide
LED # Board
Color
DS201 ADP-R42
DS118 ADP-GNSS
DS124 ADP-GNSS
DS121 ADP-GNSS
DS132 ADP-GNSS
Name
Board
J400
EVB
J300
EVB
J501
EVB
J500
EVB
J106
ADP-R42
J103
ADP-R41
J112
ADP-R42
J105
ADP-R42
J104
ADP-R41
J201
ADP-R42
J300, J301 ADP-R4x
J208
ADP-GNSS
J102
ADP-GNSS
BT200
EVB
J303
EVB
J402, J403
EVB
J405, J406
Page 11 of 31