Sharp Sound Partner User Manual page 13

Listening to Bluetooth
This unit is easy to connect/pair, voice prompts will notify you of the status.
If the voice prompt says that the battery is insuffi cient, then you are
advised to recharge the battery before proceeding to pair and connect.
If pairing is not completed within three minutes for any reason, the power
automatically turns off, with power switch still in ON the position.
To turn the device on, slide the Power Switch to the OFF position and
then back to the ON position.
Quick Connection
1
Turn on the unit by sliding the power switch towards the ON position.
The unit switches to Pairing Mode and the Blue LED turns on.
2
Perform the pairing procedure on the source device to detect this unit.
"AN-SS1 SHARP" will appear in the detected devices list (if available)
in the source device. (Refer to the source device operating manual for
further support on pairing Bluetooth
Notes:
 Place the devices to be paired within 1 meter (3 feet) of each other
when pairing.
 Some source devices are unable to display lists of detected devices.
To pair this unit with the source device, refer to the source device
operating manual for details.
3
Select "AN-SS1 SHARP" from the source list. If a Passcode* is required,
enter "0000". When connection is complete, the voice prompt will say
"PAIRED. CONNECTED.", or "CONNECTED."
* Passcode may be called PIN Code, Passkey, PIN number or Password.
enabled devices (continued)
®
devices).
®
EN-11