Ii. Connecting With The Pc; Mass Storage Mode - Medion E3140 Operating Instructions Manual

II. Connecting with the PC

1. Press the On/Off button to start your navigation system.
2. Connect the USB cable to your navigation system.
3. Push the USB connector into a free USB port on your computer.
4. The following screen will appear after the navigation system has been connected:

Mass storage mode

Note
The ActivSync® mode will be loaded automatically after a few seconds, if
no mode has been selected.
5. Select the desired mode:
Mass Storage mode
You will be able to use your navigation device as a detachable device (e.g. a USB stick) in
the Mass Storage mode. Two drives, the internal memory of the navigation system itself
and the (optional) memory card, if it has been inserted into the device, will be connected
to do this.
Note
No further entries can be made on the device at the same time if you are in
this mode. Use the 'Remove hardware safely' function of your operating
system to protect yourself against data loss. Now, remove the cable from
your navigation system.
The Hardware Installation Assistant will now recognize a new device and will install a suit-
able driver. This can take several minutes.
Appendix
ActiveSync
mode
55