Behringer OVERDRIVE OD400 User Manual

Thank you for showing your confidence in us by purchasing the BEHRINGER OVERDRIVE
OD400. This effects pedal is ideally suited for electric guitars, which need a boost in
order to overdrive a subsequent amp. Thanks to its high-performance features you can
create state-of-the-art overdrive sounds for almost any application.
The LEVEL control adjusts the output level.
The TONE control allows you to shape your overall sound.
The DRIVE control adjusts the amount of the overdrive/distortion effect.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
The OD400 has no on/off switch. As soon as you insert the plug into the IN
connector, the OD400 is on. When not in use, remove the plug from the IN
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the underside.
OVERDRIVE OD400
1. CONTROLS
Top view