Check And Replacement Of Lubricant - um CHILL 125 cc. Service Manual

Check and Replacement of Lubricating Oil
First, twist off the oil
gauge
whether the lubricating
oil becomes black or
deteriorated.
If
becomes
deteriorated, remove the
drain plug of the engine
to drain the lubricating
oil and replace it.
Level the motorcycle and
fill in oil until the oil level
is between the upper
and lower markings.
Upper oil level marking
Lower oil level marking
CHILL 125 cc. SERVICE MANUAL AND EFI DIAGNOSTIC
and check
the lubricating oil
black or
Caution
 Replace the lubricating oil when the engine is in the hot state.
 When the lubricating oil is basically drained off, turn the engine for
several times to completely discharge residual lubricating oil.
 Before filling new lubricating oil, remove the residual dirt from the
crankcase with 0.5L gasoline, and then drain the gasoline.
 The specification and grade of lubricating recommended is 10W40
engine oil is recommended.
 Check whether the filter screen, sealing gasket, spring, O-ring and oil
drain plug are in good conditions. If not, replace them.
 After replacing the lubricating oil, tighten the oil drain plug and oil fill
plug, and check periodically if there is any oil leakage.
 After replacing the lubricating oil, the idle speed of the engine must be
re-adjusted to be within the range of standard values.
6