um CHILL 125 cc. Service Manual page 14

Removal and Replacement the Rear Wheel
 Turn off the ignition lock switch.
 Use the main support to prop up the motorcycle, and take off the
silencer.
 Take off the nut of the rear wheel shaft, and remove the rear wheel.
Assembly Precautions
 In reassembly, torque to the rear wheel shaft nut: 70N.m~90N.m.
 Re-adjust the free travel of the rear braking handgrip to 10mm~20mm.
CHILL 125 cc. SERVICE MANUAL AND EFI DIAGNOSTIC
If the tread wear depth in the middle area of the tire of the motorcycle reaches
the following limit, the tire should be replaced immediately.
Minimum limit of tread
depth
Caution
 Too low tire pressure will increase the rolling resistance of the tire of
the motorcycle and increase fuel consumption. In worse cases, it may
cause local delaminating of the tire body and cause tire burst.
 Too high tire pressure will reduce the comfort of riding and fasten the
wear of each part.
Front wheel 2.0mm
Rear wheel 2.0mm
Check the tread wear depth
of the tire and whether there
is any crack. If any
abnormality is founded, the
tire should be replaced
immediately.
14