Precautions For The Run-In Period Of A New Motorcycle; Level 1 Service And Maintenance - um CHILL 125 cc. Service Manual

Precautions for the run-in period of a new Motorcycle

1. Within the run-in period, replace the oil after 1000 km, and clean the oil
filter screen.
2. Regularly check whether each connection is loose, and tighten it timely if
any loosening is found.
3. Regularly check periodically if the engine, drive system and braking system
is overheated, and whether there is enough lubricating oil on each
lubricated part. If any overheat occurs, the cause should be found at time
and be fix it.
4. Regularly check the tightness of the belt, and the free travel of the front
and rear brakes, accelerator handgrip and each maneuvering position.
Adjust them if necessary.
5. Within the run-in period, run the motorcycle after the engine is well
pre-heated. First run it at low speed for 1km~2km, and then run it at high
speed.
6. In order to reduce vibration and impact loads, the motorcycle should run
on a level road with good road conditions whenever possible.
7. Within the run-in period, overload run should be strictly forbidden.
Otherwise, the drive system will wear more faster. Heavy load should be
avoided.
8. Avoid suddenly and long-time braking.
9. Strictlycontrol the running speed of the motorcycle.
10. Within the run-in period, the load should not exceed 80% of the payload.
CHILL 125 cc. SERVICE MANUAL AND EFI DIAGNOSTIC

Level 1 Service and Maintenance

Level 1 Service and Maintenance should be performed every time after the
motorcycle runs approximately 1000km~3000km. Its main contents are as
follows:
1. Adjust the travel of the front braking handgrip to 10mm~20mm, and
adjust the rear brake pedal to 20mm~30mm.
2. Adjust the travel of the accelerator cable to 2mm~6mm, and lubricate the
accelerator handgrip and the accelerator cable.
3. Clean the fuel tank, oil filter screen and air filter.
4. Remove the carbon deposit of the spark plug, and adjust the electrode
gap of the spark plug to 0.6mm~0.7mm.
5. Remove the accumulator cell and charge it.
6. Check and tighten all bolts and nuts of all exposed parts.
7. Check the tightness of all connections of the electric system, and tighten
them properly.
8. Ajdust the engine valve lash: intake valve 0.03-0.05mm; exhaust valve
0.05-0.07mm.
4