Getting Started; Preparations; Detaching The Front Panel; Resetting The Unit - Sony XAV-C1 Operating Instructions Manual

Getting Started

Preparations

Detaching the front panel

You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel,
the caution alarm will sound for a few
seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press (OFF).
The unit is turned off.
2
Press (RELEASE), then pull it off
towards you.
OFF
Notes
• Do not drop the front panel and display window or put
excessive pressure on them.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
Tip
When carrying the front panel, use the supplied front
panel case.
(RELEASE)

Resetting the unit

Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel by pressing RELEASE
and pull it off towards you.
Use a pointed object such as a mechanical
pencil to push the Reset button. To avoid the
possibility of damage, you should not use a
needle or push the button too strongly.
Push Reset.
Reset button
Notes
• When the Reset button is pushed, the time and all
stored settings are lost and will have to be
reprogrammed.
• The reset procedure takes about 10 seconds after the
Reset button is pushed.
• When the reset procedure is completed, press OPEN/
CLOSE and verify that the monitor opens up properly.
• If you reset the unit while the monitor is open, close
the monitor once. Otherwise, it may not operate
properly.

Opening up the monitor

Press OPEN/CLOSE on the monitor.
OPEN/CLOSE
TILT
OPEN/CLOSE
9