Getting Started; Resetting The Unit; Performing Initial Settings; Setting The Clock - Sony XAV-63 Operating Instructions Manual

Getting Started

Resetting the unit

Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Press the reset button (page 10) with a pointed
object, such as a ballpoint pen.
Note
Pressing the reset button will erase the clock setting
and some stored contents.

Performing initial settings

After resetting, the display for the initial settings
appears.
Initial Setting
Rear/Sub Out
Listening Position
Name Character
1
Touch "Rear/Sub Out" to set the
subwoofer connection status.
If a subwoofer is connected, select "Sub."
If a power amplifier is connected, select
"Rear."
If neither a subwoofer or power amplifier is
connected, you can select either "Sub" or
"Rear."
2
Touch "Listening Position" to set the
listening position.
Set to "Front L" if your listening position is
front left, or "Front R" if front right.
3
Touch "Name Character" to set the
character encoding.
Touch repeatedly until the desired character
encoding appears.
4
Touch "OK."
The setting is complete.
14
Rear / Sub
Front L / Front R
Chinese
OK
This setting can then be further configured in the
setting menu.
• For details on setting the subwoofer connection
status, see page 47.
• For details on setting the listening position, see
"Optimizing sound for the listening position —
Intelligent Time Alignment" on page 39.
• For details on setting the character encoding,
see page 44.
Note
Some characters may not be properly displayed,
depending on the language/country/region.

Setting the clock

The clock uses a 12-hour indication.
1
Touch "Source List," then
The general setting menu appears. If not,
touch "General."
2
Touch "Clock Adjust."
The setting display appears.
3
Set the hour and minute.
For example, to set to 8:30, touch "0830."
4
Touch "AM" or "PM."
5
Touch "OK."
The setting is complete.
To delete an entered number, touch "Clear."
To return to the previous display, touch "Back."
Preparing the remote
commander
Before using the remote commander for the first
time, remove the insulation film.
.