Pelpro PPC90 Service Manual page 10

Error codes will look
like this on the display
Fuel Feed Alarm. Most likely the appliance ran out of fuel or the flames are adjusted
Code #1
too low.
Exhaust Temperature is above or below the acceptable range. Exhaust probe has
Code #2
failed or the flames need to be adjusted.
Ambient Temperature is above or below the acceptable range.
Code #3
Ambient probe has failed.
Missed Ignition Alarm. Appliance has either ran out of fuel or the firepot needs to
Code #4
be cleaned. Also it is possible that the igniter has failed if the appliance is clean.
Digital Display Communication Alarm. Appliance lost power while the appliance
Code #5
was running or there was a bad connection from the display to the control board.
Board may need replaced.
Exhaust temperature over heat alarm. Appliance got too hot. Check the heat
Code #7
exchanger and exhaust system for obstructions. Make sure the flame height is
correct.
10
ERROR CODE DEFINITIONS
8390-017A
REFER TO MANUAL
ERROR NR: 05
06/21