Fire Sense 63057 Assembly / Care & Use Instructions page 10

Spiral flame patio heater

Hide thumbs Also See for 63057:

NOTE:

1. Turn the control knob to the OFF position.

2. Fully open the LP cylinder valve.

3. Push in and turn the control knob counter clockwise to PILOT.

4. While holding control knob in, push the RED igniter button to ignite the main

burner. Once burner ignites, hold in control knob for 15 seconds before adjusting

the burner. Turn control knob to LO position and release the control knob.

6. To turn the appliance OFF, turn the control knob clockwise to PILOT position,

then push in the control knob and turn clockwise to the OFF position.

7. Wait at least 5 minutes before attempting to re-light the heater.

8. Turn the gas cylinder valve to OFF or closed.

Caution:

FOR YOUR SAFETY

Be careful when attempting to manually

ignite this heater. Holding in the control

knob for more than 10 seconds before

upon ignition.

Note:

1. Turn control knob to OFF.

2. Wait at least 5 minutes to

allow gas to dissipate before

re-lighting.

3. Repeat the "Lighting" steps

listed above.

63252 63258