Advertisement
Available languages
Available languages
Instructions d'installation / Installation instructions : F6313T955
Ensemble Adaptateur F63 / Adapter Kit F63: K27760 for Claas
Step 6: Drive chain installation
Install the three drive chains as shown.
Adjust the two binders to obtain a
total play of 1/4" on the slack side.
If required, the input shaft can be slid
sidways to tighten the triple chain
(28) by loosening the 4 bearing bolts
(30).
Step 7: Optional Installation
Give the crop channel (31) to the client/operator WITHOUT INSTALLING IT. The
channel is used only for dry conditions to reduce ear losses. It prevents losses between
the header and the feedrolls in these tough conditions. It must be removed to operate
in normal conditions to avoid the risk of plugging. To install, use the bolts holding the
two guides below the rear idler sprockets (32). Lthe guides in place even when the
channel is installed.
14 avril 2014
TM
harvesters
9
Advertisement
