Installing The Camera - Lorex E893AB Series Quick Start Manual

Installing the camera

1. Use the included mounting template
to mark holes for the screws.
2. Use a 3/16" drill bit to drill holes for the
mounting screws. Insert the included
drywall anchors if you are installing the
camera in drywall.
3. Connect cables as shown in "Connecting
the camera" pg.10-11.
4. Feed the cable through the mounting
surface or cable notch and mount the
camera stand to the surface using the
included screws.
5. Use a Philips screwdriver to loosen the
adjustment screw and adjust the camera
position as needed (see Figure 2).
6. Tighten the adjustment screw to secure
the position.
7. Remove the vinyl film from the camera
lens when your installation is complete.
Figure 2
Adjustment screw
Tilt the camera on
the stand up to 90°
Twist the camera
around the stand 360°
11