Advertisement
Step 5.
Remove the Rear Panel
Refer to
Figure
5-1.
1. Turn the instrument over to expose the bottom side of the instrument.
2. Disconnect the thermistor switch by removing two screws (item
3. Cut the two tie wraps that bundle the blue and red cables, and the gray and white/gray
y
cables (item
).
4. Disconnect the red and blue fan wires (item
5. Using needle-nose pliers, disconnect the five transformer wires and one gray wire
from the line module (item
6. Using a flat blade screwdriver loosen, but do not remove, the nine screws on the green
connectors and disconnect the eight transformer wires (item
yellow/green/yellow, and purple/blank/purple.
Figure 5-1
Power Supply Cable Removal
16
z
) from connector J3.
{
).
x
).
|
): red/blue/red,
08757-90195
Advertisement
