Step 4.
Remove the CRT
Recycle or dispose of the cathode ray tube (CRT) in accordance with
NOTE
applicable environmental laws.
Refer to
Figure
4-1.
1. Remove the connector clip from connector J4 and unplug the large ribbon cable (item
2. Disconnect white power cable (item
connector J1 on the power supply board. Discard the power cable. A new power cable with
eight conductors is provided in the upgrade kit.
3. Disconnect the rear panel ribbon cable (item
Figure 4-1
CRT Removal
4. Disconnect the gray CRT ribbon cable (item
board.
5. Remove the graphics board.
6. Slide the CRT out of the front frame.
14
y
) from connector J1 on the graphics board and
z
) from connector J2.
{
) from connector J3 by lifting the graphics
x
).
08757-90195