Adjust (20 Mph); Preset (45 Mph) - Dakota Digital ECD-200BT Manual

Adjust (20 MPH): - LED: ""
• Needle should be pointing to 20 MPH (32 km/h).
• Press and hold the switch until the needle drops to 0 MPH. Then release the switch.
• The needle will move to 15 select to decrease your speed or 25 to increase your speed.
• Tap the switch to change the selection, press and hold the switch until the needle moves to
zero. LED: ""
• Release the switch and the needle will now operate normally as you drive.
• Drive at a constant speed, follow another vehicle, use a GPS, or use some other method to
verify your actual speed.
• Holding the switch for one second will change the speed by about 1 MPH in the direction
selected. Press and hold the switch to change the speed reading more quickly.
• If you go past your desired speed, you will have to go back through setup and choose the
other direction, to make a fine adjustment.
• When no changes have been made for 10 seconds, the new calibration will be saved.
• If the input is set to ", the needle will not move and the LED will display ""
Preset (45 MPH): - LED: ""
• The LED readout will also display along with the needle movements.
• Needle should be pointing to 45 MPH (72 km/h).
• Press and hold the switch until the needle drops to 0 MPH – LED: ""
• Release the switch.
• The following pulse per mile (PPM) presets are available:
o 10 MPH = 4000 ppm
o 20 MPH = 8000 ppm
o 30 MPH = 16000 ppm
o 40 MPH = 64000 ppm
o 50 MPH = 128000 ppm
0 MPH = factory preset
o
• Press and release the switch to change the selection press and hold to save.
• Saving will drop the needle to zero, and show "" in the LED display
• Tap switch until "" is displayed, then hold the switch or turn the key off to exit setup.
LED: 
LED: 
LED: 
LED: 
LED: 
LED: 
5
MAN# 650704B