(Electronic Stability Program) - Mercedes-Benz G Series Operator's Manual

ELEC. STABIL. PROG. (Electronic stability program)
Line 1
ESP NOT ACTIVE
ESP NOT ACTIVE
ELEC. STABIL. PROG.
ELEC. STABIL. PROG.
DISPLAY DEFECTIVE
* C = Category, see page 272
Malfunction and warning messages
Instruments
Operation
and controls
Line 2 C*
1
LOCK SELECTED 1
2
LOCK ACTIVE 1
3, 4, 5, 6
NOT AVAILABLE! 2
3, 7
VISIT WORKSHOP! 2
8
VISIT WORKSHOP! 2
Instrument
Driving
cluster display
1 Transfer case differential lock is selected, the ESP is not available,
see page 243.
2 Transfer case differential lock is active, the ESP is not available,
see page 243.
3 The enhanced vehicle stability offered by ESP and the torque
reduction feature are unavailable.
4 This message may be displayed if the power supply was
interrupted (battery disconnected or empty). Synchronize ESP, see
page 244
5 The system is temporarily unavailable. The reason could be that
the self-diagnosis has not been completed. The display will clear
itself after driving a short distance at more than 12 mph (2o km/h).
6 The system is unavailable due to low voltage, e.g. battery not being
charged.
7 A malfunction has been detected in the system. In case of ESP
malfunction the ESP warning lamp in the instrument cluster
illuminates and the ESP switch in the center console does not
function. If in addition the ABS is malfunctioning, only partial
engine output will be available.
8 The display or the system is malfunctioning.
279
Practical hints Car care
Technical
Index
data