Care And Maintenance - Britax Roundabout User Manual

Care and Maintenance

Child Seat Cover Removal
WARNING! Do not take apart or attempt to take apart
the harness. Never remove the buckle tongues from the
harness. They cannot be reattached after removal. If assembled
incorrectly, the child seat may not perform as intended.
1 Loosen the harness by pressing the harness
adjuster button while pulling the shoulder
straps forward as far as possible.
2 Unhook the shoulder straps from the harness
yoke on rear of child seat (Fig. A).
3 Pull the upper harness straps through the
shell and cover to the front of child seat.
4 Gently remove the upper portion of the
cover. Be careful not to damage the energy-
absorbing foam.
5 Remove the buckle and belly pad by turning
the metal buckle strap retainer of the buckle
on the underside of the child seat so the
short side will slide through the child seat
shell (Fig. B).
6 Push the retainer through the slots in the shell and cover to the
top of the child seat.
7 Pull the lower harness straps, buckle tongues, and chest clip
through lower slots in cover.
8 Remove the entire cover from child seat.
For additional demonstration please visit www.BritaxUSA.com.
34
Refitting the Cover
To refit the cover, reverse the previous directions. Make sure the
shoulder straps are properly threaded through the chest clips and
the harness is not twisted.
Cleaning the Cover
• HAND WASH using cold water and mild soap.
• LINE or LIE-FLAT DRY to prevent cover from shrinking.
• DO NOT
Cleaning the Shell
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY
• DO NOT
A
harness.
Cleaning the Harness
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY
• DO NOT
the harness.
B
Care and Maintenance
bleach, machine wash, machine dry or iron.
use solvents, abrasive cleaners or disassemble the
bleach, machine wash, machine dry or disassemble
35