Lap-Belt Installation - Britax Roundabout User Manual

Installation: Forward-Facing

Lap-Belt Installation

• Figure A illustrates a typical forward-facing, lap-belt
installation.
• When not in use, always store the LATCH connectors
in storage slots. See page 30.
WARNING! This child seat must not
be used forward-facing for children
less than one year of age OR weighing less
than 20 pounds.
IMPORTANT:
Britax recommends that the Versa-
Tether ® be used at all times. Using the tether will
improve the stability of the child seat and reduce the
risk of injury. Check your vehicle owner's manual for
approved tether anchor locations.
1 Place the child seat forward-facing on the
vehicle seat.
• Child seat may be in upright or recline position. See
Recline Adjustment on page 30.
2 If the vehicle is equipped with an approved
tether anchor for the chosen seating position,
remove the Versa-Tether
over the child seat back.
3 Pull the vehicle belt out and thread it through the forward-
facing belt path (Fig. B).
4 Verify that the vehicle belt is not twisted and buckle (Fig. C).
5 Push the child seat firmly into vehicle seat while tightening the
vehicle belt.
22
Forward-Facing Forward-Facing
A
B
C
® from the pouch and place it up and
6 If the vehicle is equipped with an approved tether anchor,
attach the Versa-Tether ®
Remove all slack from tether to secure. Store excess webbing in
the tether pouch. See pages 25 – 28.
7 Verify that the vehicle belt is tight, locked, and child seat is
secure.
• The child seat is secure when it cannot be moved front-to-back or side-to-
side more than 1 inch (2.5 cm.) at the belt path.
Removal
• If connected, disconnect the Versa-Tether
anchor.
• Press the red release button on the vehicle belt buckle and pull
the vehicle buckle from the child seat belt path.
Installation: Forward-Facing
hook to an approved tether anchor.
® from the tether
23