Swapping Sections; Deleting A Section; Naming A Section; Setting The Pad Illumination Colors - Roland VERSELAB MV-1 Owner's Manual

Swapping Sections

Here's how to swap (exchange) performance data and tones together
between sections.
1 .
Press the [COPY] button.
The menu screen appears.
2 .
Use the [VALUE] dial to select "SWAP: SECTION," and then
press the [VALUE] dial.
The SECTION SWAP screen appears.
3 .
Use the [VALUE] dial to select the swap source section, and
then press the [VALUE] dial.
4 .
Use the [VALUE] dial to select the swap destination section,
and press the [VALUE] dial.
A confirmation message appears.
* To cancel the operation, press the [EXIT] button.
5 .
Use the [VALUE] dial to select "OK," and then press the
[VALUE] dial.
The performance data and tones for the sections are now swapped.

Deleting a Section

This deletes all contents in a section. This reverts the tones (tones/
drum kits) to their default settings (presets).
1 .
Press the [SECTION] button to set the workflow to "Section."
2 .
Press the [SECTION SELECT] button to switch the pads to
Section Select mode.
3 .
Press pads [1]–[16] while holding down the [CLEAR] button to
select the section to delete.
A confirmation message appears.
* To cancel the operation, press the [EXIT] button.
4 .
Use the [VALUE] dial to select "OK," and then press the
[VALUE] dial.
The section's performance data is deleted.

Naming a Section

You can name each section separately.
1 .
Press the [SECTION] button to set the workflow to "Section."
2 .
Press the [SECTION SELECT] button to switch the pads to
Section Select mode.
3 .
Press pads [1]–[16] to select the section to name.
4 .
Press the [EDIT] button, and then press the [VALUE] dial.
The section name edit screen appears.
Cursor (blinking)
5 .
Edit the section name.
You can change the character shown at the cursor position.
Operation Explanation
MEASURE [<] [>] Selects the character to edit.
[VALUE]
Edits the character.
[SHIFT] + MEASURE [>] Inserts a space.
[SHIFT] + MEASURE [<] Deletes the character.
[CLEAR] Deletes the character and replaces it with a space.
6 .
Press the [VALUE] dial.
The section name is now changed.

Setting the Pad Illumination Colors

You can set the illumination color of the pads for each section.
1 .
Press the [SECTION] button to set the workflow to "Section."
2 .
Press the [SECTION SELECT] button to switch the pads to
Section Select mode.
3 .
Press the [EDIT] button, and then press pads [1]–[16] to select
the section for which the pad illumination color is to be
changed.
The SECT SETTING screen appears.
4 .
Use the [VALUE] dial to select "Color," and then press the
[VALUE] dial.
5 .
Use the [VALUE] dial to select the pad illumination color.
Section Operations
17