Harness Height Adjustment; Adjusting Buckle Position - Britax Regent User Manual

Harness Height Adjustment

1 Loosen the harness by lifting the harness
release lever while pulling the shoulder straps
forward as far as possible (Fig. A).
2 From the rear of the child seat, unhook
the shoulder harness straps from the yoke
(Fig. B).
3 Pull the harness straps through the shell, foam
and cover to the front of the child seat.
4 Thread the harness straps through the
appropriate harness slots in the cover, foam
and seat shell. (Fig. C).
5 Reattach harness straps to the harness yoke.
WARNING! HUGS chest pads must be
™
used at all times.
6 Pull harness adjuster strap to tighten the
harness.
7 Verify that all straps are threaded at the
same height and are not twisted.
32
The
should
(Fig. A). Select the slot closest to, but not under,
the child.
A
Remove the buckle, then rethread in appropriate position. See
page 36 for buckle removal and rethreading instructions.
B
C
buckle has two positions
be adjusted to fit
WARNING! Do not use position two (2)
until child exceeds 50 pounds (22.7 kg).

Adjusting Buckle Position

and
your child
A
33