Versa-Tether - Britax Regent User Manual

Versa-Tether

®
WARNING!
Attach the Versa-Tether only to tether anchors designated by your
vehicle manufacturer as tether anchorage points. Use of other locations
is not approved or permitted.
Do NOT modify the vehicle without advice from the vehicle
manufacturer if a tether anchor is not available.
Do NOT hook the Versa-Tether to the bottom of a vehicle seat
adjuster.
Always use the Versa-Tether for children weighing more than 50
pounds (22.7 Kg).
Always use the Versa-Tether when installed in the lap-shoulder short-
route mode of installation.
Britax recommends that the tether be used at all times. Using the
®
tether will improve the stability of your child seat and reduce the risk
of injury.
If your vehicle does not currently have a tether anchor attachment, refer
to your vehicle owner's manual or contact your vehicle manufacturer
for assistance.
26
Using the Versa-Tether
1 Consult your vehicle owner's
manual for approved tether
anchorage locations.
2 Locate the tether on the back
of the child seat. Place the
tether components up and over the child seat back.
3 Install the child seat using the LATCH system or the vehicle seat
belts according to the instructions in this manual.
4 Lift the tether adjuster tab to release the tether straps, then pull
to fully extend the tether into a "V" shape.
5 Locate the hook on the strap.
6 Hook the tether to the vehicle's designated anchor point (Fig.
A).
7 Pull the tether adjuster belt to remove all slack.
8 Verify that there is tension in the tether strap and that the child
seat is properly secured.
The child seat is secure when it cannot be moved front-to-back or side-to-
side more than 1 inch (2.5 cm) at the belt path.
Versa-Tether
1
OR
2
A
®
27