Maintenance - Pro-Cut KG-32 Owner's Manual

MEAT GRINDER
VI.- CLEANING
For cleaning the Grinding Unit, follow the next procedure:
1. Disassemble main components as explained before on the installation section.
2. Using a soft bristle brush not provided -See Fig 4, clean with adequate detergent each component, specially inside headstock
(10) to eliminate waste and debris of food.
3. Wash every component with plenty of water.
4. Dry completely. Don't let soap cleaners dry on the surface.
5. It is important after doing this procedure, to lubricate the knife (15) and plate (16) with the included mineral oil. Assemble again.
IMPORTANT!:
Avoid use of abrasive cleaners, acid, fibers, chlorides (such as chlorine bleach), on stainless
steel surfaces will cause pitting, corrosion, and metal discoloration. Allowing salty solutions
to evaporate and dry on stainless steel may also contribute to corrosive conditions.
VII.- MAINTENANCE
This equipment is designed to have a minimal maintenance, but, it´s important to check the next points:
1. The knife (15) and plate`s hole (16) always must have sharp edges. Replace them after certain period of use or if you notice the
quality of the grinded meat is not as fine as the first time.
2. Replace the knife and plate when assembly becomes loose even though the Ring (17) is totally tight.
3. If the power cord (3) or the plug is damaged, it must be replaced by an authorized service technician or qualified personnel to
avoid risk of electric shock.
4.- Lubricate the entrance of the headstock in the transmission cover when if you see that the approved grease (24) has been
consumed by use or cleaning. Apply only food contact approved grease contained in the bottle. It is important to always keep
lubricated this area to be easy the disassembling of headstock.
5.- The gear box of this grinder is sealed and should be repaired or opened only by approved technician, the transmission oil should
be changed at least every two years of normal operation.
CAUTION!:
Always unplug or disconnect the machine from the power supply before cleaning or
perform any maintenance.
6
FIG.6 TIP FOR CLEANING ROUGHNESS PARTS
KG-32