Related Manuals for Pro-Cut KG-12-FS
Summary of Contents for Pro-Cut KG-12-FS
- Page 1 KG-12-FS INSTRUCTIONS FOR OPERATION, SERVICE, AND MAINTENANCE KG-12-FS PRO-CUT MEAT GRINDER 507127-0...
-
Page 2: Table Of Contents
OF HIGH QUALITY LONG LASTING MATERIALS THAT SHOULD GIVE YOU YEARS OF TROUBLE FREE OPERATION AND SERVICE. BEFORE YOU UNPACK YOUR NEW PRO-CUT GRINDER, IT IS VITAL THAT YOU AND ANY PERSON THAT WILL OPERATE THIS UNIT THOROUGHLY READ THIS MANUAL. -
Page 3: Unpacking
TOO TIGHT, USE ONLY HAND FORCE. E.- INSTALL THE PRODUCT TRAY(2): MODEL KG-12-FS: WITHDRAW THE NUTS(22) AND WASHERS(21), PUT THE SUPPORT TRAY(10) AND REPLACE WASHERS(21) AND SCREW NUTS(22) WITH WRENCH(29) INCLUDED WITH THE UNIT, NOW INSERT THE NECK OF THE TRAY(2) INTO THE HEAD STOCK (13) AND PLACE THE BACK PART OF THE TRAY(2) ONTO THE SUPPORT TRAY(10). -
Page 4: Operation
2.- PLACE THE GRINDER ON A FIRM AND CLEAN SURFACE THAT HAS ACCESS TO AN ELECTRICAL POWER SOURCE, AND BE SURE IT MEETS THE POWER REQUERIMENTS OF THE UNIT. (IF YOU HAVE ANY QUESTIONS PLEASE CONTACT YOUR PRO-CUT DEALER). 3.- ASSURE THAT ALL LOCAL ELECTRICAL CODES ARE COMPLIED WITH. -
Page 5: Maintenance
KG-12-FS 4.-TO CLEAN CASE (5) ENCLOSURE USE DAMP CLOTH WITH DETERGENT (NEVER HOSE DOWN OR SUBMERGE CASE ENCLOSURE IN WATER OR OTHER LIQUID). RINSE WITH A DAMP CLOTH AND DRY. 5.- REASSEMBLE THE MAIN COMPONENTS TAKING CARE OF THE PIN(9) ALIGNMENT IN THE HEAD WITH THE NOTCH ON THE BOTTOM OF THE PLATE . - Page 6 KG-12-FS REVIEW BY CONSUMER FREQUENCY OF COMMENTS VERIFICATION HEADSTOCK RING (20) ONCE A YEAR PART REVIEW THREAD SO PREVENT ACCIDENTS BAD JOIN IN THE HEAD NOT ON THE TEAM WITH THE HEAD FULL OF DAILY PRODUCTS AND / OR BECAUSE THIS CAUSES...
- Page 7 KG-12-FS IX.- ELECTRIC DIAGRAM KG-12-FS: DIAGRAMA ELECTRICO ELECTRICAL DIAGRAM KG-12-FS PRO-CUT...
- Page 8 KG-12-FS X.- PARTS LIST KG-12-FS: MODEL: KG-12-FS: THANK YOU FOR READ THIS MANUAL. ANY QUESTION PLEASE CONTACT YOUR PRO-CUT DEALER.