Travel Mode Selector Switch - Hitachi ZW 370-6 Operator's Manual

Travel Mode Selector Switch

Travel mode selector switch (1) selects the travel mode.
Selecting the manual mode "
selector switch (1) switch 1 sets the transmission to manual
mode, which allows manual shift change by using shift switch
(2). AUTO 1 and AUTO 2 are choices selectable at auto-shift
mode. Select the most efficient mode for the travel and work
condition.
Be sure to stop the machine and set forward/reverse lever
(2) in the neutral (N) position before operating travel mode
selector switch (1).
Manual Mode : Manual gear shift (The gear shifts
according to the shift switch.)
AUTO 1 Mode : Starts out traveling at 2nd speed. When
traveling load increases, it automatically
shifts from 2nd to 1st speed. (Auto DSS
function)
This mode is suited for heavy digging
work or climbing a slope.
AUTO 2 Mode : Starts out traveling at 2nd speed. This
mode shifts between 2nd ~ 3rd ~ 4th
speeds.
This mode is suited for loading loose
material, removing snow or a similar
application.
Refer to "MOVING THE MACHINE" section.
f
NOTE: The AUTO 1 mode shifts up to the set shift lever
position. When the shift switch lever is set to 4th speed, auto-
shift range is 1st to 4th speed. When the shift switch in set to
3rd speed, auto-shift range is 1st to 3rd speed.
f
NOTE: When AUTO1 or AUTO2 is selected on the machine
with optional stick steering system without the steering
wheel, the shift up and shift down switches at the steering
lever do not work.
OPERATOR'S STATION
" by using travel mode
1-107
1
AUTO 1 Mode
Manual Mode (neutral)
AUTO 2 Mode
2
1
F
2
N
3
R
4
1
MNEC-01-041
MNEC-01-024
MNEC-01-037