WilTec 51701–51703 Operation Manual page 9

4. fig. 12: Turn the second rear hopper tube so that the brace
holes in the middle of the tube face up. Assemble the ends of
the rear hopper tube onto the ends of the lower hopper side
tubes. Fasten together using plastic plugs.
№ Name
1 Rear hopper tube (brace holes on top)
2 Lower hopper side tube
3 Plastic plug
5. fig. 13: Place the assembled low hopper tubes into the bot-
tom of the hopper bag.
6. Attach the ends of the lower hopper side tubes to the inside
of the upper side tubes using two Ø9.5×25 clevis pins inserted
from the inside, and two hair cotter pins Ø3.
№ Name
1 Upper hopper side tube
2 Clevis pin Ø9.5×25
3 Lower hopper side tube
4 Hopper bag bottom
5 Hair cotter pin Ø3
7. fig. 14: Insert the bag frame strap into the stitched sleeve
along the front edge of the bag bottom.
8. Assemble the bag frame strap to the lower hopper side
tubes using two Ø6×37 clevis pins and two Ø2 hair cotter pins.
№ Name
1 Hair cotter pin Ø2
2 Clevis pin Ø6×37
3 Bag frame strap
9. fig. 15: Secure the bag corners around the lower hopper
side tubes by snapping the bag flaps to the bag bottom on
both sides.
№ Name
1 Flap
2 Snap
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 51701–51703 Page 9
01 2021-1