Advertisement
Important: Do not over-bend the support rods during the fol-
lowing step. Over-bending will cause the steel rods to loose
their supporting tension.
10. fig. 16: Tip the hopper onto its back to assemble the two
hopper support rods (1). Place the ends of each rod into the
upper and lower rear hopper tubes bending the rod just
enough to fit it into the holes in the tubes.
№ Name
1
Upper hole
2
Lower hole
3
Upper hopper side tube
4
5
11. fig. 17: Feel along the stitched flap on the hopper bag to locate the lower hole in each upper hop -
per side tube. Place a hole through both sides of the stitched flaps in alignment with the lower hole.
12. fig. 18: Insert a Ø8×59.5 clevis pin through the lower hole in each upper hopper side tube. Next
assemble a bag arm tube onto each clevis pin and secure it with a Ø3 hair cotter pin.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Name
Vinyl cap
Bag arm tube
Lower hole
Clevis pin Ø8×59.5
Hair cotter pin Ø3
Item 51701–51703
Page 10
01
2021-1
Advertisement
