Advertisement
Assembly
REMOVE THE HARDWARE PACK AND ALL LOOSE PARTS FROM THE BOX
AND VERIFY THAT ALL THE PARTS AND FASTENERS SHOWN ON THE LAST PAGE
Sweeper assembly
Note:
Right hand (R. H.) and left hand (L. H.) are determined from the operator's position on the
tractor.
1. fig. 1: Connect the angle bracket to the sweeper housing
using a M8×16 hex bolt and a M8 hex lock nut. Make sure that
the bracket is turned as shown and aligned stsraight with the
housing, then tighten.
№
Name
1
Hexagonal lock nut M8
2
Angle
3
Hexagonal bolt M8×16
2. fig. 2: Assemble the R. H. hitch tube to the sweeper hous-
ing using a M6×40 hex bolt and a M6 lock nut. Do not tighten
yet.
3. Repeat for the L. H. hitch tube.
№
Name
1
Hexagonal bolt M6×40
2
Hexagonal lock nut M6
4. fig. 3: Fasten the hitch tubes together using two M8×65 hex
bolts and M8 lock nuts. Do not tighten yet.
№
Name
1
Hexagonal bolt M8×65
2
Hexagonal lock nut M8
The tractor hitch ground clearance determines how to pro-
ceed:
– clearance from 279 to 330 mm > fig. 4
– clearance from 203 to 279 mm > fig. 5
5. fig. 4 u. 5: Assemble the hitch brackets to the hitch tubes using two M8×50 hex bolts and M8 hex
lock nuts. The bolts should straddle the front hitch tube bolt. Do not tighten yet.
6. Now tighten the four bolts fastening the hitch tubes to the sweeper housing. Next tighten the two
bolts fastening the ends of the hitch tubes together. Finally tighten the two bolts fastening the hitch
brackets to the hitch tubes.
7. Assemble the hitch pin, the spacers and the hair cotter pin to the hitch brackets.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
ARE INCLUDED.
Item 51701–51703
Page 6
01
2021-1
Advertisement
