Advertisement
10. fig. 8: Position the height adjustment handle side to side
so that the external teeth washer can fit between the handle
and the height adjustment strap. Tighten the nuts securing the
height adjustment handle.
№
Name
1
Big flat washer Ø8
2
Carriage bolt M8×65
3
External teeth washer
4
Wing screw
11. fig. 9: Assemble the connecting rod to the sweeper hous-
ing by using two sets of M6×12 hex bolt and M6 lock nut.
№
Name
1
Connecting rod
2
Hexagonal bolt M6×12
3
Hexagonal lock nut M6
Hopper bag assembly
1. fig. 10: Turn a rear hopper tube so that the brace holes in
the middle of the tube face down. Slide the tube through the
two loops sewn to the top rear seam inside the hopper bag.
№
Name
1
Inner bag loops
2
Rear hopper tube (brace holes on bottom)
2. fig. 11: Insert the two upper hopper side tubes through the
flaps stitched on each side of the hopper bag.
3. Assemble the ends of the rear hopper tube onto the ends of
the upper hopper side tubes.
№
Name
1
Plastic plug
2
Upper hopper side tube
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 51701–51703
(Abb. 8)
(Abb. 9)
Page 8
01
2021-1
Advertisement
