Baumatic Studio Solari AS26SS Instruction Manual page 10

ELECTRICAL CONNECTION
Before connecting the appliance, make sure the supply voltage marked on the rating Plate
corresponds with the mains supply voltage.
WARNING – THIS APPLIANCE MUST BE EARTHED
This appliance should be wired into a double pole Switched Fused Spur Outlet having 3 mm
contact separation and the fuse rating reduced to 3 Amps.
IMPORTANT
The wires in the main supply lead are coloured in accordance with the following code:-
Green and Yellow
Blue
Brown
The connections must be made as follows:-
The wire coloured Green and Yellow must be connected to the terminal marked 'E' or the earth
symbol (⊥) or coloured green and yellow.
The wire coloured Blue must be connected to the terminal marked 'N' or coloured blue or Black.
The wire coloured Brown must be connected to the terminal marked 'L' or coloured brown or
red.
NOTE: The terminals marked 'SUPPLY' are for the mains supply wires and the terminations
marked 'LOAD' are for the appliance wires.
The electrical outlet is to be positioned in an easily accessible position adjacent to the appliance.
In the event that it is necessary to replace the mains supply lead, the replacement must conform to
the specification listed in the Technical Data. Ensure that the colour code connection is correct
and that all screws are tightened correctly.
MAINTENANCE
During the guarantee period, in case of need all service intervention should be referred
back to the Baumatic Ltd Service department. Please note that intervention or repair by
any unauthorised personnel will invalidate such guarantee,
Before carrying out any maintenance, disconnect the appliance from the gas and electricity
supplies.
If a gas tap becomes stiff to operate, proceed as follows:
•
Remove the control knobs, pan supports, burners and hob fixing screws & clamps.
•
Remove the Hob from the worktop and remove any underside protective covers.
•
Disconnect the fixings holding the tap to the fascia panel, separate the assembly, then clean
the cone and seating with a cloth dampened with solvent.
•
Lightly smear the cone with high temperature grease, reassemble into position and rotate a
few times. Remove the cone again and remove any excess grease making sure that the gas
ducts are not obstructed with grease.
•
Carefully reassemble the components and check for gas soundness.
If it becomes necessary to replace the gas tap, proceed as follows:
•
Disconnect the appliance as described above.
9
– Earth
– Neutral
– Live