Plumbing; Flush Before Using Equipment; Accessories - Graco President 24H627 Instructions-Parts List Manual

4-ball pumps
Table of Contents

Advertisement

Installation

Plumbing

See F
. 2. Install a fluid shutoff valve (D) between the
IG
mix tank (A) and the pump.
When using a stainless steel pump, use stainless steel
plumbing to maintain a corrosion-resistant system.

Flush Before Using Equipment

The equipment was tested with lightweight oil, which is
left in the fluid passages to protect parts. To avoid con-
taminating your fluid with oil, flush the equipment with a
compatible solvent before using the equipment. See
Flushing, page 9.

Accessories

Install the following accessories in the order shown in
F
. 2, using adapters as necessary.
IG
Air Line
Bleed-type master air valve (M): required in your
system to relieve air trapped between it and the air
motor when the valve is closed.
Trapped air can cause the pump to cycle unexpect-
edly, which could result in serious injury from splash-
ing or moving parts. Be sure the valve is easily
accessible from the pump and located downstream
from the air regulator. Be sure the air bleed hole
points away from the operator.
To help prevent fluid overpressurization, do not
exceed the maximum air inlet pressure rating to the
air motor (see page 2). If you can apply more than
the maximum air input pressure to the system, install
a safety relief valve between the bleed-type master
air valve and the air motor. The safety relief valve
must be set to open if the air inlet pressure to the
motor exceeds the motor rating.
6
Pump air regulator (L): to control pump speed and
outlet pressure. Locate close to the pump.
Air line filter (K): removes harmful dirt and mois-
ture from compressed air supply.
Second bleed-type air valve (H): isolates air line
accessories for servicing. Locate upstream from all
other air line accessories.
Fluid Line
Fluid filter: with a 60 mesh (250 micron) stainless
steel element to filter particles from the fluid as it
leaves the pump.
Fluid drain valve (N): required in your system, to
relieve fluid pressure in the hose and gun.
Fluid shutoff valve (D): shuts off fluid flow.
3A1450B

Advertisement

Table of Contents
loading

Table of Contents