Digital Display; Operation Mode - Omron H5AN Manual

Operation
■ Timing Chart

Digital Display

UP Display
Note: After the set time has elapsed, operation continues according to the mode (N, F, C, R, K, P, or Q).

Operation Mode

(The control output and digital display when the set time is up differ in each of the operation modes available.)
Mode UP display
N
F
C
R
http://www.ia.omron.com/
DOWN Display
(See note)
(See note)
DOWN display
(c)Copyright OMRON Corporation 2008 All Rights Reserved.
H5AN
(See note)
(See note)
Operation after the set time is up
The control output and digital display
are held until a reset input is applied.
In UP mode, the digital display
continues to increment up to "9999"
even after reaching the set value and
then returns to all zeroes. In DOWN
mode, the digital display continues to
up 9999, and then decrements "9998,
9997, ...," after reaching all zeroes.
The control output is held until a reset
input is applied.
The digital display returns to the initial
setting once the set time has elapsed
and the timer restarts the timing
operation.
When the set time has elapsed, the
output signal is generated during the
one-shot time. The timer repeats this
cycle.
The digital display returns to the initial
setting after the one-shot time and the
timer restarts the timing operation.
When the set time has elapsed, the
output signal is generated during the
one-shot time. The timer repeats this
cycle.
4